Blanchard #48-96, 96" Vertical Spindle Rotary Surface Grinder

• Tag Number: 16128
• Machine Type: Grinding Machines
• UMCC: G8100
• Manufacturer: Blanchard
• Model: 48-96
• Year: 1966
• Serial Number: 12187
• Description: Blanchard #48-96, 96" Vertical Spindle Rotary Surface Grinder

Overall Specifications

• STANDARD SPECIFICATIONS
• Range:
• 108" diameter x 24" high over 96" chuck with new segments. In loading position 48" segment chuck clears 96" magnetic chuck by 2". Extended swing and vertical range available.
• KVA Requirements:
• 150 HP.
• Work Table:
• Blanchard one-piece steel 96" diameter magnetic chuck with 1 1/16" pole spacing and 4" center hole. Chuck uses direct current only. 3,845 watts required - supplied by Neutrofier when ordered. 230 volts DC recommended. Maximum weight of off center work load on chuck - 22,000 pounds.
• Wheel:
• 48" Cortland type bonus grind segment chuck. Chuck uses 8" long CDTXL bonus grind segments, 11 per set.
• Speeds:
• Wheel: 297 RPM - 60 HZ; 248 RPM - 50 HZ.
• Chuck: 2.6, 4.1, 6.7, 10.2 RPM - 60 HZ; 2.2, 3.4, 5.6, 8.5 - 50 HZ.
• Chuck motor: 1200 RPM - 60 HZ; 1000RPM - 50 HZ.
• Table traverse motor: 1200 RPM - 60 HZ; 1000 RPM - 50 HZ.
• Head traverse motor: 900 RPM - 60 HZ; 750 RPM - 50 HZ.
• Feed motor: 1800 RPM - 60 HZ; 1500 RPM - 50 HZ.
• Feed:
• Vertical down feed by hand or power. Power feed variable from.008" (.2mm) to .096" (2.44mm) per minute with accurate automatic stop. Maximum down feed before stop operates is .600" (15.24mm). Wheel head has rapid raise and lower by power interlocked with feed.
• Motor Data: 440 volt, 3PH, 60 cycle, 34 frame, 207 amp, 354 rpm
• Standard Equipment:
• 96" Blanchard one-piece steel magnetic chuck; water guards, piping; jogging push button for chuck positioning; water valves; hardened steel base ways with semi-hydrostatic automatic lubrication to base ways; automatic lubrication to column ways, feed screw nut, and wheel dresser; operator's handbook; wheel dresser built into head; set of wrenches; and grease gun; 150 HP main spindle motor; 10 HP chuck rotation motor; torque motors for table traverse and head rapid traverse; 1/4 HP feed motor; reduced voltage push button control and ammeter in wheel motor circuit. Floor mounted control panel (N.E.M.A. - 12 enclosure) containing reduced voltage (star) starting and full voltage (delta) running starters, for main motor, line starters for small motors with thermal overload protection for all motors, and non-fused disconnect switch interlocked with door.
• Weight:
• Approximately 87,000 lbs. depending upon accessories.
• NOTE: Machine came out of Running Plant. Machine is clean and in excellent condition.
• Price below reflects "As taken from service". Rebuild price available upon request.